Faroudja Native Rate Series, Инструкция по установке и эксплуатации

Страница: 9 / 46

SYSTEM FIRMWARE SETUP
7
Should always be On
LCD Display Backlight Timer
5-255 seconds (Default 10)
Sets how long the front panel LCD stays on.
Red LED Brightness
0-15 (Default 8)
Front panel LED brightness
Green LED Brightness
0-15 (Default 8)
Front panel LED brightness
OSD Vertical Position
0-255(0=Top)
This sets the single line adjustment OSD position.
OSD Timer
4-255 seconds (10 Default)
HDTV Ext. Format
480p / 720p / 1080i
This option is accessible and only needs to be
set if the Transcode option is selected for the
pass-thru.
HDTV External Input (D15) (Pass-Through)
Pass-thru / YPrPb to RGB
HDTV Component External Input (BNCs)
Pass-thru / YPrPb to RGB
Note: When the component BNC inputs auto-
detect a HDTV signal then this command
is activated as the signal is sent to the
pass-though
Note: The HD Pass-through inputs can transcode
YPrPb HDTV signals to RGBHV. It cannot
transcode RGBHV signals to YPrPb. Sync
on Green is NOT available when using the
HD Pass-through input.
Note: Blanking and image position controls can be
returned to the Factory default setting by
pressing the Factory button when accessing
that control.
Bottom Blanking
This adjusts the bottom edge blanking
Right Blanking
Adjusts the right edge blanking
Left Blanking
Adjusts the left edge blanking
Top Blanking
Adjusts the top edge blanking
Blanking Gray Level
This adjusts the blanking from black to white. This
can be used to create a gray side bar for use with
4:3 aspect ratio sources on wideangle screens to
help prevent image burn-in.
Vertical Sync Polarity
Negative / Positive
Changes sync polarity which may be needed for
compatibility with some displays.
Horizontal Sync Polarity
Negative / Positive
Changes sync polarity which may be needed for
compatibility with some displays.
Y/C Delay Adjustments: The following commands
allow for aligning the RGB color timing to the
luminance timing. These adjustments should only
be done by a qualified technician. A Y/C delay test
pattern must be used for proper alignment, such
as the Y/C delay pattern in the AVIA test DVD. The
range of adjustment is 0-6, 3 is the default center
and the timing can be ad-3 steps. Be sure
to adjust the Green position first.
Blue Y/C delay
0-6, 3 default
Red Y/C delay
0-6, 3 defaul t
Green Y/C delay
0-6, 3 defaul t
Sync on Green
On/Off(Default)
Vertical Position
0-64, 32 default
Moves image up from center
Horizontal Position
0-170, 85 default
Moves image left or right of center
Note: moving the image too far to the left or right
can cause the display to stop working. Use
positioning controls in the display first–
if available.
RGB Input Sync
Sync on Green / Ext. Sync High / Low
(Low sync is used with PAL sources where
composite video is applied as sync with RGB)
Sync on Y
Bi-level
Tri-level