4
FRONT PANEL CONTROL
1. Firmware Reset:
push a small paper clip into
this opening to reset the unit’s CPU.
Note:
Use this reset only if the unit will not
respond to commands. It will not erase
custom settings. Use the Factory Restore
command in the Setup Menu to completely
reset firmware. See the setup section of the
manual for details.
2. Power/Standby:
Press to turn the unit On
(LED turns Green) or to Standby (Red).
3. Infrared Receiver Window
4. LCD Readout:
Provides information on control
of the processor. Displays current Function
being used, matching the On-Screen-Display.
When in the Setup Menu, the OSD is not
available, use the LCD display.
SYSTEM FIRMWARE SETUP
Now that all the sources and cables are connected,
the processor’s firmware needs to be setup for the
installation.
Be sure to go through the Setup menu
before doing the final setup of the display.
When the unit is first plugged in it will go through an
initializing procedure and display the output
resolution. Do not send any commands to the unit
during this initialization period. Once this initialization
is completed the unit is instant-on.
Note:
All display devices have specific setup
steps that must be completed to insure proper
operation with the DVP1000 and other
sources. Be sure to carefully
follow those instructions as well as
the instructions for this processor.
To enter the Setup menu, press and hold
the Menu button on the remote for five seconds.
Setup Functions can only be viewed on the front
panel LCD, not from the OSD.
Press the Function Up or Down to select the available
Functions. Press the Value Up or Down keys to
change values or to select options.
SETUP MENU FUNCTIONS
Set: SCANRATE
Select the required scanrate by using the right and
left arrows. When the desired rate is displayed on the
LCD display, press the STORE key. The DVP1000 will
ask you "Are you sure" and press the STORE key
again. The scanrate is now selected.
Set: Active Output
Analog/Digital (Default)
This must be selected to determine if the Analog
(BNC) or Digital (DVI) output is used.
Both outputs
cannot be used at the same time.
Set: Screen Shape
Wide Screen / 4:3 / Wide 4:3
Note: This sets the processor for the screen shape of
the
display
to be used. If this is not set properly, the
aspect ratio selection for the different sources
located in the user menu will be incorrect.
• Wide Screen
-Choose this when the screen is
Widescreen and the projector will provide the
anamorphic vertical squeeze.
Example: A 16:9 plasma, a digital or CRT projector
set to Anamorphic using a wide angle screen or when
using a Panamorph lens, or a 1280x720 digital
projector.
• 4:3
– Choose this when the projector is 4:3
and the screen is 4:3
Example: using a 1024x768 digital projector on a 4:3
screen.
• Wide 4:3
-Choose this when the digital
projector operates as 4:3 and the screen is
Widescreen. (Not available on units scanning
at rates below 720p)
SETUP
1 2
3
4
