FarmTek Sunblocker 2020SPC, Руководство пользователя

Страница: 7 / 17

7
CANOPIES
Revision date: 05.31.16
Leg
166P077
Pipe Identification
Location Pipe Quantity
Leg 166P077 1
INSTALL LEGS
This section is an overview of the process for attaching
your legs to the roof frame. See illustration below to identify
main parts of the frame.
1. Using the leg pipes, insert the legs into the 3-way and
4-way couplers of the main frame.
Do not install the
main frame legs during a storm or windy day
.
2. Secure each pipe in the coupler using the locking
eyebolt. If the couplers are not equipped with locking
eyebolts, secure each pipe in the coupler using a Tek
screw.
ATTENTION : If used, position Tek screws so they will
not touch the main cover when installed.
3. Inspect the frame for sharp edges or Tek screws that
could damage the covers. Reinstall the Tek screws if
necessary (or rotate the pipes) and remove or tape any
sharp edges.
4. After the entire frame is assembled, verify that each
locking eyebolt is tight.
5. Set the frame in the desired location and measure
diagonally from corner-to-corner to square the frame.
The diagonal measurements will be identical when the
frame is square. Verify width between leg pipes.
6. Properly anchor the assembled frame as described in
the MUST READ document included with the shipment.
NOTE:
DO NOT install the cover without anchoring the
frame.
7. After anchoring the frame, continue with attaching the
main cover.
166P077