5
GREENHOUSE BENCH KITS
Revision date: 10.26.21
2
Gather two (2) 96" tubes, two (2) 44" tubes, four (4) 2-way corner fittings, and the assembled center brace
from Step 1.
Slide the 44" tubes through the 3-way fittings first, and then assemble as shown below.
Set the outside-to-outside dimensions and measure diagonally to verify that the frame is square. (See
dashed lines below.) Frame is square when both diagonal measurements are the same.
After squaring the frame and setting the outside-to-outside dimensions, secure each corner connection
using Tek screws. Position Tek screws on the inside of the frame—two at each corner fitting.
IMPORTANT:
The 96" tubes will span the
entire length of the bench. Verify that the open
ends of the 2-way corner fittings are positioned
to accommodate the whole tube. See diagram
to the right.
Slide 44" tube
through the
3-way fitting.
44" T
ube
96" T
ube
Center Brace
96" T
ube
44" Tube
44" Tube
Tek
screws
1/4"
96" Tube
44" T
ube
ATTENTION:
Leave 1/4" space between the end of the 96"
tubes and the open corner edge.
Outside-to-Outside Dimensions
WIDTH: 48"
LENGTH: 96-1/2"
96-1/2"
outside-to-outside
48"
outside-to-outside
Install Tek screws on the back or
inside of each corner fitting.
