Visit
www.ClearSpan.com
for additional products and customer assistance.
CLEARVIEW
™
PANELS
ClearView
™
Panel
PREPARE THE FRAME
Gather the Tools and Materials
Tape measure or measuring device
•
With the help of an assistant, hold the panel centered
on the outside of the frame.
Mark the frame where each upper corner of the panel
will be located.
Draw a straight line between the marks on the frame.
This assures the panel hangs straight and does not sag
in the middle.
1.
2.
3.
HANG THE PANEL
Gather the Tools and Materials
Variable speed drill or screwdriver
3/8'' Nut Setter or 3/8'' socket
Tek Screws or non-corrosive wood screws
Fender Washers or 1/4'' non-corrosive flat washers
•
•
•
•
With the help of an assistant, hold the panel along the
straight line drawn on the frame.
Insert a screw with a washer through the panel into the
frame in either upper corner of the panel.
NOTE:
If the frame is metal use a self-drilling Tek
screw with a fender washer. If the frame is wood use
a non-corrosive wood or decking screw with non-
corrosive flat washer.
1.
2.
The bottom of the panel may be attached to a deck
railing, the floor, or a 2'' X 4'' screwed to the floor.
Attach the bottom of the panel using screws and
washers at least every 24''.
6.
Hold the panel tight and insert a screw with a washer
into the opposite upper corner of the panel.
Hold the upper edge of the panel on the line and insert
screws with washers at least every 24''.
Attach the sides of the panel to the frame using screws
with washers at least every 24''.
3.
4.
5.
