FARMSCAN 30007000-7999, Руководство пользователя

Страница: 11 / 21

10 WWW.FARMSCANAG.COM AM-JACKAL-B / OCT 2018
CALIBRATION (AUTO SET)
1. Ensure that the sensor and pickup are end-end before continuing
2. Mark bottom centre of tyre on which the sensor is fitted and peg ground in corresponding position
3. Measure out a known distance to calibrate i.e. 20m
4. Peg the corresponding point i.e. at the 20m mark
Press the down arrow to
Select TARGET
Select EDIT
Using the NAV buttons enter
your measured distance. i.e.
20.0000
Press EXIT when done.
Press START and move
forward slowly.
This will allow pulses to
register.
When you arrive at the
center mark point of tyre to
peg press STOP
Press CALC. This will divide
the distance travelled by the
number of pules registered.
MANUAL RATIO will now be
updated.
Press NEXT
Using the NAV buttons select
how you would like the area
to be displayed on the front
screen.
Press NEXT
Press EDIT to change the
input name or
Press NEXT to continue
Select km/h or mph to
display the speed on the
front screen.
You have the option to set
Alarm Min/Max points if
required. Using the NAV
buttons select and EDIT as
required.
Press NEXT
Press EDIT to change the
input name or
Press NEXT to continue
Press the UP arrow to
highlight the width.
Press EDIT & use the NAV
buttons to change the
implement width. E.g. 12m.
Pressing EDIT will change the
Unit of Measure
Press NEXT .
Press EXIT & NEXT to
finalise the setup of the
Speed & Area Wizard.
If you have a 2
nd
sensor
connected to Input 1 press
NEXT to continue the
wizard.
THIS ENDS THE AUTO SET WIZARD SETUP FOR SPEED/AREA METER