Manual
SOFTER 15 PS | 20 PS
17
│
23
The same number of washers must be set
on all piston rods!!!
Transfer ratio between thickness of distance
elements and working depth is approximately
1:3.
E.g.: Adding or removing one washer with the
thickness of 0.12in changes the working depth
of the machine by 0.32 – 0.35in
.
Tab.7 shows the individual working positions
and number of washers needed to achieve the
required machine depth
.
The position of the tracing wheel for the
individual depths is provided in Tab. 7 in the
first column. The number of the position in the
table corresponds with the number of the
opening for the pin on the tracing wheel arm.
Specified working depths at individual positions
are only for information. They may vary
according to particular soil conditions. It is
possible to add or remove a required number of
washers as needed
.
Tabl.7 – Setting of working depth
5.2
MACHINE ADJUSTMENT USING TRACTOR´S TPS ARMS
With the use of the TPS shoulders of the tractor adjust the machine so that the front and rear row discs work in
the same depth.
Fig.9 – Machine Adjustment
TPS shoulders of
the tractor
půda
Rám stroje v rovině s půdou
Setting the depth by
rear rollers
Setting the same depth for front and rear disc rows
Position of tracing
wheel
Number of
washers
Working
depth
