Farmet K400NS, Руководство по эксплуатации

Страница: 16 / 42

Manual
KOMPAKTOMAT K400NS | K500NS | K600NS
16
│
42
3. MACHINE ASSEMBLY AT THE CUSTOMER

Always assemble the machine on a flat and reinforced surface.
 Use the Spare Parts Catalogue with 3D views as reference for assembly.
 The operator must perform the assembly according to the instructions of the producer, best in
cooperation with the expert servicing technician determined by the producer.
 The operator must secure a functional test of all assembled parts after the completion of the machine
assembly.

The operator must secure that the handling of the machine using lifting equipment during its assembly is
in accordance with chapter
„C“ /p.8.
4. COMMISSIONING
 Before taking over the machine, test and check, whether damage occurred during transport and
whether all parts contained in the bill of delivery were supplied.
 Before commissioning the machine, carefully read this operating manual, especially Chapters A-D page
6-11. Before the first use of the machine, familiarise yourselves with its controls and overall function.
 During work with the machine, observe not only the instructions of this operating manual but also
generally valid regulations of work safety, health protection, fire and transport safety, and
environmental protection.
 The operator must check the machine before every use (commissioning) from the standpoint of
completeness, work safety, work hygiene, fire safety, transport safety, and environmental protection.
 A MACHINE SHOWING SIGNS OF DAMAGE MUST NOT BE COMMISSIONED!!
 Aggregation of the machine with the tractor is to be performed on a flat and hardened surface.

When working on slopes, observe the lowest slope grade of the set TRACTOR - MACHINE .
 Before starting the tractor motor, check whether no person or animal is in the working space of the set
and push the warning sound signal.

The operator is responsible for the safety and all damage caused by the operation of the tractor and the
connected machine.
 The operator is obliged to adhere to the technical and safety regulations of the machine determined by
the producer when working.

The operator must raise the machine when turning at the plough turning end, i.e. the working parts
must not be in the ground.

The operator is obliged to observe the prescribed working depths and speeds stated in the manual in
table page 5 when working with the machine.
 The operator is obliged to lower the machine to the ground and secure the set against movement
before leaving the tractor cabin.

When connecting, no persons may stay in the space between the tractor and the machine. Exercise
utmost caution!
4.1 AGREGATION TO A TRACTOR

The machine can be connected only to a tractor, whose curb weight is identical or higher than the
overall weight of the connected machine.
 The machine operator must observe all generally valid regulations of work safety, health protection, fire
safety, and environmental protection.
 The operator may connect the machine exclusively to a tractor that is equipped with a rear three-point
hitch and a functional undamaged hydraulic system.

The controlling distributors in the tractor must be secured or blocked when the machine is in the
transport position or when the machine is not in use to prevent accidental or third-party (children,
passengers) caused movement of the hydraulics.

Aggregate the machine with the tractor using type and dimensionally consistent components
corresponding to the output requirements.