Manual
DISKOMAT 3 | 3,5
14
│
19
The machine features high stability during operation. However turning of machine to one
side may occur with fault adjusted longitudinal plane (particularly in heavy soils). This is
removed by modification of tractor arm height as follows:
-
When turning the machine to the left, the front discs are set lower => lift the machine in the
tractor arms and extend the third-point drawbar
-
When turning the machine to the right, the front discs are set higher => recess the front
part of the machine in the tractor arms and shorten the third-point drawbar
5.3
SETTING THE SIDE DEFLECTOR
Set the height of the side deflector so that it can catch soil flying from the front edge disc and thus create
a levelled surface between the individual operating drives.
5.4
FIXING THE POSITION OF THE ROLLER
Use the top pin on the rear frame gate to secure undesirable falling of rear frames with the roller to the
main frame of the machine when lifting at the headland. Insert the top pin in the closest hole to the
position stop after the machine has been recessed.
