FARM-MAXX FFM145, Руководство оператора и каталог запасных частей, Страница: 40 / 62

6.7. DRIVE BELTS REPLACEMENT
Frequently check the wear of the belts, and if one or more of these appears worn replace the full set.
To replace the drive belts, refer to the section “Belts tensioning adjustment”.
6.8. DRIVESHAFT MAINTENANCE
Lubricant: AGIP GREASE MU EP 2 lithium-type grease (or equivalent)
Frequency: each 20 working hours
Grease crosses, sliding parts of protective shielding and driveshaft transmission tubes.
IMPORTANT
For details about maintenance and lubrication of the driveshaft, refer to the user manual of the driveshaft
Manufacturer.
NOTE
For the driveshaft service parts, refer to the user manual of the driveshaft Manufacturer.
7. STORAGE
Before leaving the machien unused for a long time, it’s necessary to perform following tasks to preserve
the appearance and functionality of the machine, and to make easier the restart at later use:
• park the Flail Mower on a flat surface, in a place dry and protected from exposition to the elements,
• possibly with storage temperature between 0 and 50 °C (see section Stopping and disconnection);
• thoroughly clean the machine, removing from the rotor all residues due to shredding, in order to avoid
damage from grass and stagnant water;
• inspect carefully the machine, checking for worn and/or damaged parts. Perform immediately all repairs
and/or replacements needed, in order to make the machine ready for restarting;
• in case of abrasion of painted surfaces, provide restoring the surface protection through touchup paint
to prevent rust;
• make sure the safety decals are in their original positions, intact and legible. When required, replace
the decals immediately;
• lubricate properly all grease points, and restore the oil levels as indicated in the Maintenance section.
Use protective oil to coat the exposed mechanical components and to protect them against rust.
8. SCRAPPING
In case of scrapping, the machine must be disposed in appropriate and authorized sites, according to local
legislation.
Before scrapping, separate plastic parts from rubber parts, aluminum, steel, etc.
Recover and dispose any exhausted oils to authorized centers for oil collecting.