Farm King RT17, Руководство оператора и каталог запасных частей

Страница: 26 / 84

Operation - RT17, RT19 Tedder
24
Connecting to Tractor
Three-Point Hitch
Always inspect the tractor’s three-point hitch and
equipment three-point mounts before connecting.
Move the tractor drawbar into the storage position
or remove (if necessary) to prevent interference
with equipment operation (See the tractor’s
operator’s manual for the correct procedure).
Figure 2
Remove the top implement mounting pin (Item 1)
and retaining clips
[Figure 2] .
Remove the retaining clips from the left and right
lower mounts (Item 2)
[Figure 2].
Enter the operator’s position (See “Entering The
Operator’s Position” in Operation section).
Move the tractor into position in front of the
equipment. Move the tractor backwards, aligning
the tractor’s three-point hitch and equipment
three-point mounts.
Leave the operator’s position (See “Leaving The
Operator’s Position” in Operation section).
Install the left and right lower three-point mounts
of the tractor to the equipment left and right lower
mounting pins.
Reinstall the retaining pins.
Note: Always use retaining pins with a locking
device.
Lower the top link of the three-point hitch until it
aligns with the implement upper mount.
Reinstall the mounting pin and retaining pin.
Note: It may be necessary to lengthen or shorten
the top link to align it with the implement
mounting hole. (See the tractor’s operator’s
manual for the correct procedure.)
The implement can be leveled front to back by
adjusting the top link (See the tractor’s operator’s
manual for the correct procedure).
Adjust the lower link sway chains or blocks on the
tractor to restrict side movement of the equipment
when operating.
The support jack (Item 3) [Figure 2] must be fully
raised when operating.
WARNING
AVOID INJURY OR DEATH
Before moving the tractor, look in all directions
and make sure no bystanders, especially small
children are in the work area.
Do not allow anyone between the tractor
and the equipment when backing up to the
equipment for connecting.
Keep fingers and hands out of pinch points
when connecting and disconnecting
equipment.
1
2
3
2