Farm King BW200, Руководство оператора и каталог запасных частей

Страница: 31 / 82

Operation - 200 Bale Wrapper
29
Wrap Counter
Figure 12
The wrap counter (Item 1) is an electronic device
used for counting the wraps on a bale and may be
used on all types of wrapping machines. The wrap
counter should be installed in the tractor cabin in
a place where it is visible and accessible to the
operator
[Figure 12] .
Protect the counter against humidity, excessive
vibration and hitting the cabin elements, and
especially against falling on a hard surface. The
counter can be fixed by using its back surface
catch.
WARNING
Protect the meter from water, chemical agents,
direct atmospheric precipitation, frost, high
temperature in excess of 50°C and direct exposure
to sunlight.
The counter kit comprises of:
• Pre-programmed counter in a plastic casing
• Revolution sensor
• Bundle of wires
• Multi-contact connection
The revolution sensor attached to an unmoving
part of the wrapping machine operates in
conjunction with a magnet attached to the rotary
chassis which passes impulses to the revolution
counter. Each rotation of the bale is counted
and displayed on the revolution counter display.
When the programmed number of revolutions is
performed, the counter signals the completion of
the wrapping process with a blinking light and
sound signal. The counter may be programmed
to a required number of revolutions between ten
and forty-nine.
Connect the revolution sensor installed in the
cabin to the power source (12V) and revolution
sensor by using the specially prepared bundle of
wires.
IMPORTANT
Protect the wires connecting the sensor with the
revolution counter against accidental mechanical
damage.
Protect the connections of the wires with the
revolution counter against accidental uncoupling.
Switching the System ON and OFF
The blinking red signaling light indicates that the
revolution counter system has been configured
properly. Press and hold the ON button marked
with the letter C. Each activation of the counter is
accompanied by the display test and the power
supply voltage test.
A positive test result indicates the unit is ready
to work with the settings entered during the
previous use. Press and hold the C button until
a red blinking light appears on the display (for
about 3 seconds). After this signal, the counter
unit may be disconnected.
1