FARGO electronics HDP700 Series, Техническое обслуживание и руководство по эксплуатации, Страница: 132 / 141

FARGO Electronics Inc.
HDP700 Series Card Printer A-7
Figure 7-10
5. Measure the distance from the leading edge of the card to the leading edge of the transferred
image.
6. Calculate the
Transfer TOF
value for inches or mm.
Inches: 60 – (Measurement x 300):
Millimeters: 60 – (Measurement x 11.8).
Example:
Inches: 60 – (.050 x 300) = 45:
7. Adjust the
Transfer TOF
value.
8. Press
SELECT
to save the value.
9. Print a test card as described in step 1.
10. Repeat steps 1 to 9 until the test image is correctly positioned.
7.3.5 Setting the Transfer EOF
This procedure controls the point on the card at which the Transfer Roller lifts, and ceases
transfer. Refer to Section 7.3.1 for proper sequence.
1. Choose
MENU
,
Print Test Image
, and
Gray/Align YMC
to print a test card.
2. Examine the test card. The Inner Alignment Arrows should appear at the trailing edge, and
the Outer Alignment Arrows should not appear on the card. If your test card does not look
Figure 7-7, go to step 5 to adjust the Transfer EOF.
3. Record the
Transfer EOF
value on the test card last printed.
4. Select MENU, Setup Printer, and Transfer EOF.
5. Measure the distance from the trailing edge of the card to the trailing edge of the image
transfer.
6. Calculate the
Transfer EOF
value for inches or mm.
Inches: -90 + (Measurement x 300)
Millimeters:-90 + (Measurement x 11.8).
Example:
Inches: -90 + (.050 x 300) = -105
7. Adjust the
Transfer EOF
value. Decrease the Transfer EOF value to move the end of the
transferred image toward the leading edge of the card; increase the Transfer EOF value to
move the end of the transferred image toward the trailing edge of the card. Remember, ±30
pixels will move the transferred image 0.100 in. (3.84mm.)
8. Press
SELECT
to save the value.
9. Print a test card as described in step 1.
10. Repeat steps 1 to 9 until the test image is correctly positioned.
Refer to Figure 7-10.
NOTE
If the inner alignment arrows are not printing on the card — but are just off the edge — decrease the
Print Offset setting by two or three pixels. The entire inner alignment arrow will not show up on the
card. More important is that the card shows equal amounts of the arrows.