ENGLISH
ENGLISH
GB-11
GB-10
towards “6” and check after one hour.
NOTE:
The Fridge/Freezer may not operate at
the correct temperature if it is in a particularly
hot or cold room or if you open the Fridge/
Freezer door too often.
Thermostat
control dial
Please Note:
If the appliance is switched off you must wait at
least 5 minutes before restarting the appliance or
re-inserting the plug into the wall outlet. This is
to allow the protection device in the compressor
to reset.
If the compressor fails to start correctly remove
the plug and wait for 5 minutes before you
try again then the compressor should restart
normally.
The storage temperature may be affected by:
• The room temperature
• How often the door is opened
• How much food is stored
• Position of the appliance
SETTING THE THERMOSTAT KNOB
The refrigerator is controlled with a thermostat
knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
the STOP (0/OFF) position towards the higher
numbers for colder temperatures. The knob can
be adjusted from setting 1 to 7.
Higher settings on the knob (higher numbers)
mean lower temperatures (colder) in all
compartments of the appliance.
Changes of the ambient temperature affect
temperature in the interior of the appliance
so choose a correct setting of the temperature
control knob, depending on your ambient
conditions.
In the STOP (0/OFF) position the appliance
does not operate (the cooling system is switched
off), but power supply is not interrupted.
Please start with the knob set to position
“4.5”. Use a suitable thermometer to check the
temperature after two hours. The refrigerator
temperature should be set b2ºC and +5º
and the freezer will vary between -18 and -25
degrees centigrade over a typical cycle. To reduce
the refrigerator temperature turns the knob
