Com.X Administrator Guide
Page 134
across telco interfaces, one would replace the SIP trunks here with trunk
groups that contain the trunks to be used.
•
Create two outbound routes, one using the first SIP trunk and the other the
second SIP trunk (or the appropriate telco trunk groups).
•
Create two FlexPaths, and add an Include rule that includes the appropriate
outbound route for each. Point the first FlexPath to the first outbound route
and the second to the second outbound route.
•
For network load-balanced scenarios, log into the Com.X using ssh and
configure two routes for routing the traffic across the two network paths in
/etc/network/interfaces:
auto eth0
iface eth0 inet dhcp
post-up ip route flush dev eth0
post-up ip route add 10.0.0.1 via 192.168.0.1
post-up ip route add 10.0.0.2 via 192.168.0.2
3.12.11.11 FXO Trunk pick-up to test for trunk service
When installing a Com.X, at times it might be useful to determine whether a specific
trunk port has been service provisioned by a device connected to the port. For
example, the installer might want to check whether a legacy PBX is providing dial-
tone in the trunk, or a premi-cell is available. This might also be of use if the wiring to
the Com.X1 is not clearly marked, to determine which trunks have service.
Configuration:
•
create an outbound route called 'trunk-tester' with dial pattern '99!' and the
trunk of interest included in the trunks list
•
Dial 99
Configure for automatic test on pickup:
•
Replace the dial pattern above with '!'
•
create a FlexPath called 'trunk-tester' and use the Include mode to include the
'trunk-tester' outbound route
•
on the FlexPath panel, assign an extension port to the trunk-tester FlexPath
and plug a phone into the extension port
•
select the extension port in the Hardware panel and enable Immediate mode
•
Pick up the handset. If the service is active you'll hear dial-tone or the service
prompt.
Note: If immediate mode is not set for the automatic test configuration, the Com.X
will still provide dial-tone on the extension as usual, which might be incorrectly
perceived as an external trunk service, so be sure to enable Immediate mode on the
extension port.
3.13 Call recording
Please note that the call recording features provided by Far South Networks
products are best-effort services and do not meet the requirements for
©2010 –
2016
Far South Networks
Содержание Com.X
Страница 34: ...Com X Administrator Guide Page 34 Figure 26 Global Settings 2010 2016 Far South Networks ...
Страница 99: ...Com X Administrator Guide Page 99 3 7 4 2 Advanced configuration 2010 2016 Far South Networks ...
Страница 110: ...Com X Administrator Guide Page 110 Figure 92 SIP trunk basic configuration options 2010 2016 Far South Networks ...
