32
User will see the call message in the middle of current screen. The device will not be ringing but playing call
waiting tone in the audio channel of the current call and the LED will be flashing in green. User can accept or
reject the call as same as normal incoming call. When the waiting call is answered, the first call will be put on
hold automatically.
Picture 18 - The second call interface
Second Outgoing Call
To make a second call, user may press [
Xfer
] / [
Conf
] button to make a new call on the default line or press
the line key to make new call on specific line. Then dial the number the same way as making a phone call.
Another alternative for making second call is to pressing DSS Keys dial out from the configured Keys
(BLF/Speed Dial). When the user is making a second call with the above methods, the first call could be
placed on hold manually first or will be put on hold automatically at second dial.
Switching between Two Calls
When there are two calls established, user will see a dual calls screen as the following picture.
Picture 19 - Two way calling
User can press up/down navigator buttons to switch screen page, and switch call focus by pressing [
Resume
]
button.
Ending One Call
User may hang up the current talking call by closing the audio channel or press [
End
] button. The device will
return to single call mode in holding state.
8.3 End of the Call
After the user finishes the call, the user can put the handle back on the phone, press the hands-free button or
Softkey [
End
] key to close the voice channel and end the call.
Note! When the phone is in the reserved state, the user must press the [Resume] key to return to the
call state, or put the receiver back and press the hands-free hook to end the call.
8.4 Redial
Redial the last outgoing number:
When the phone is in standby mode, press the redial button and the phone will call out the last number
dialed.
Call out any number with the redial key:
Enter the number, press the redial key, and the phone will call out the number on the dial.
Press the redial key to enter the call record:
