Fanvil Technology Co. Ltd
Addr:10/F Block A, Dualshine Global Science Innovation Center, Honglang North 2nd Road, Bao'an District, Shenzhen, China
Tel: +86-755-2640-2199 Email: [email protected] [email protected] Official Web:www.fanvil.com
3.
How to change network mode for iW30
There are two ways to check iW30’s IP address, via "volume up" button and via web page
management system. Please check the following steps for detail. The default network mode for
iW30 is Static IP mode with default IP address 192.168.1.128. If the network mode of iW30 is
Static IP, you can change it to DHCP. If the network mode of iW30 is DHCP, you can change it to
Static IP with IP address 192.168.1.128.
3.1.
Change network mode for iW30 via "volume up" button
Step1.
Refer to the above connection diagram, connect iW30 to PoE switch.
Step2.
After iW30 starts up and gets into standby mode:
Long press its "volume up" button for 10 seconds, the beep sound will ring out and last for 5
seconds. Press the "Volume up" button three times continuously during the 5 seconds to change
the network mode. After it had network mode changed successfully, the device broadcast its IP
address later.
3.2.
Change network mode for iW30 via webpage
Step1.
Load the web page management system of iW30.
Step2.
Go to web page “Network” -> “Basic”, set the network mode as you need, and then click “Apply”
button to save your changes.