15
Figure 12 - MCAST
Table 4 - MCAST
Parameters
Description
Enable Auto Mcast
Send the multicast configuration information by Sip Notify
signaling, and the device will configure the information to the
system for multicast listening or cancel the multicast listening in the
system after receiving the information
Auto Mcast Timeout
Delete Time
When a multicast call does not end normally, but for some reason
the device can no longer receive a multicast RTP packet, this
configuration cancels the listening after a specified time
Priority
The priority defined in the current call, 1 is the highest priority and
10 is the lowest.
Enable Page Priority
Regardless of which of the two multicast groups is called in first,
the device will receive the higher priority multicast first.
Name
Listened multicast server name
Host:port
Listened multicast server’s multicast IP address and port.
Multicast
：
Go to web page of [
Function Key
] >> [
Function Key
] , select the type to multicast, set the
multicast address, and select the codec.
Click Apply.
Set up the name, host and port of the receiving multicast on the web page of [
Intercom
Settings
] >> [
MCAST
].
Press the DSSKY of Multicast Key which you set.
Receive end will receive multicast call and play multicast automatically.
