For further inquiries, please contact our Customer Service Team
Email: [email protected] Phone: 888-961-7727
11
INITIAL START-UP
-
When the spa is first
powered up the control system begins a 2 minute
Startup Mode. Different codes will display on the
screen. Once Startup Mode completes, the actual
temperature is displayed on the screen, and the
spa will then begin to heat and maintain the water
temperature and the first filter cycle will start. Your
spa has been designed so that it will automatically
heat the water to the factory set temperature of
100
°
F (38°C) unless you set the spa to a different
temperature. If power is disconnected from the
spa, it will automatically revert back to the last
saved set temperature when power is reapplied.
TEMPERATURE ADJUSTMENT
80°F - 104°F (26.5°C - 40°C)
The temperature can only function between
80°F - 104°F (26.5°C - 40°C). The last measured
temperature will constantly display on LCD.
Press the
Plus
or
Minus
buttons to display the
set temperature and indicator . Each time either
button is pressed again, the set temperature will
increase or decrease depending on which button
is pressed. After five seconds, the LCD will
automatically display the current spa temperature.
The “heater” indicator
lights up when the
heater is on. It flashes when there is a request
for more heat, but the heater is not on. Once set
temperature is reached the indicator shuts off
and the low speed of the jet pump turns off after
30 seconds (if not in filter cycle).
JETS OPERATION
Firmly press the
Jets
button once to activate the
low speed of the pump and again for the high
speed. Firmly press the
Jets
button again to turn
off the pump. If left running the low or high speed
pump will automatically turn off after 1 hour. The
"Jets" indicator light next to the button will blink
when jet pump is on low speed and is solid on
high speed.
MULTI COLOR LED LIGHT
Press the
Light
button once to turn on the light,
the light indicator next to the button is lit when the
light is on. Press the button again to turn the light
off. Every time the light is quickly turned off and
on a new light mode will appear. The sequence
is as follows: White, Full color wheel, Amber,
Blue, Red, Green, Purple, color wheel 1,
color wheel 2 and abrupt color wheel. The last
light mode used will come back on when the light
is turned off for more than 2 seconds.
NOTE:
If left
on, the light will automatically turn off after 4 hours
of operation.
FILTER CYCLES
There are two filter cycles: the first cycle (F1)
starts right after power up and the second cycle
(F2) will start 12 hours later. The default duration
for the first filter cycle is 1 hour, and 30 minutes
for the second cycle. Filter cycles only run at low
speed. The “Filter” indicator lights up when a
filter cycle is on. The duration of each filter cycle
can be modified.
ADJUSTING PRESET FILTER
CYCLES
Filter duration is programmable between 0.5 and 6
hours in 30 minute increments (0.5 hours) for both
filter cycles. To program the cycle times:
1. Press and hold
Program Mode
button for 5
seconds until F1 is displayed.
2. Press the
Plus
or
Minus
button to adjust
the cycle time for F1.
3. Press the
Program Mode
button to store
the F1 cycle and move to the F2 cycle.
CONTROL PANEL OPERATION
Jets
Indicator Lights
Temp Minus
Temp Plus
Light
Program
Mode