Step 3
Page 7
fantasticfurniture.com.au
You will need
Phillips Head
Screwdriver
18 x Screws
12mm (H18)
6 x Slides
(H19)
Mallet
H19
Separate the 6 x slide runners (H19-2) and slide tracks (H19-1)
from the slides (H19) by following the steps below:
Extend the slide runner (H19-2) all the way out.
Press down the plastic release lever on the slide track (H19-1)
and pull out the slide runner (H19-2) completely.
H19
Slide runner H19-2
Slide track H19-1
H19-1
H19-1
Note the position of the rubber stopper
Attach 6 x separated slide tracks (H19-1)
onto side panel (P3, P4) with 18 x screws (H18),
using a phillips head screwdriver as shown.
Ensure the slide tracks (H19-1) are attached so the rubber stopper is positioned
near the grooves on side panel (P3, P4) as shown.
Screw 2 x cam bolts (H1) into each side panel (P3, P4),
using a phillips head screwdriver.
Insert 4 x dowels (H3) into each panel (P3) & (P4) as shown.
If needed use a mallet to gently tap the dowels into place.
Adjust runner to access the screw holes.
H19-1
8 x Dowels
ø8mm (H3)
4 x Cam Bolts
(H1)
(P3)
(P4)
H3
H3
H3
H3
H3
H3
H3
H3
H1
H1
H1
H1
H18
H18
H18
H18
H18
H18
H18
H18
H18
H18
H18
H18
H19-1
H19-1
H19-1
H19-1
H19-1
H19-1
H19-1
Please fasten the screws through
these holes for this step.
