Step 4
Page 7
fantasticfurniture.com.au
You will need
Phillips Head
Screwdriver
6 x Screws
12mm (H18)
2 x Slides
(H19)
Mallet
H19
Separate the 2 x slide runners (H19-2) and slide tracks (H19-1)
from the slides (H19) by following the steps below:
Extend the slide runner (H19-2) all the way out.
Press down the plastic release lever on the slide and pull out
the slide runner (H19-2) completely.
H19
Slide runner H19-2
Slide track H19-1
H19-1
H19-1
Note the position of the rubber stopper
Attach 2 x separated slide tracks (H19-1) onto side panels (P3, P4) with 6 x screws (H18),
using a phillips head screwdriver as shown.
Ensure the slide tracks (H19-1) are attached so the rubbber stopper is near
the grooves on side panels.
Screw 4 x cam bolts (H1) into side panels (P3, P4), using a phillips head screwdriver
as shown.
Insert 4 x dowels (H3) into the left side panel (P3) and 4 x dowels (H3) into
the right side panel (P4).
If needed use a mallet to gently tap the dowels into place.
Adjust runner to access the screw holes.
H19-1
8 x Dowels
ø8
mm (H3)
(P3)
H3
H18
H3
H3
H3
H3
H3
H3
H3
(P4)
H19-1
H19-1
H1
H1
H1
H1
H18
H18
H18
4 x Cam Bolts
(H1)
H19-1
Please fasten the screws
through these holes for this step
