2
Fantasea Nano Fiber Optic Cable Kit Instruction Manual 20110120
Instructions for Use
1.
Attaching the Fiber Optic Cable to the Slave Strobe
a.
The fiber optic cable consists of two ends: One is
attached to a white plastic fitting (flat white
plastic at the end of the cable with Allen screw
inside), and the other is loose (figure A).
Insert the exposed end of the fiber optic cable
(the end without the fitting) into the small hole
of the adaptor unit, starting from the end that
features a screw and pushing it towards the end
that features an O-ring, until the fiber optic cable reaches the end of the
adaptor.
b.
Use the tool you have received with your fiber optic cable kit in order to
tighten the screw on the adaptor. Tighten it enough to stabilize the fiber
optic cable inside the adaptor, but don't tighten it too strongly.
Tightening
the screw too much might damage the fiber optic cable.
c.
Carefully but firmly insert the black adaptor inside the proper fitting in front
of the strobe's slave sensor.
If attaching the fiber optic cable to the
Fantasea
Nano Flash
(Cat. No. 6115), install
the black and clear plastic diffuser cover on the
Nano Flash Housing, if it isn't already
assembled. Insert the black adaptor inside the
lower right grommet (the one with the wider
hole) of the black diffuser cover, so that the
adaptor screw doesn't get in its way. Insert it
all the way to the end, and do not use force
once you encounter any resistance (figure B).
2.
Attaching the Fiber Optic Cable to the Camera Housing
a.
If attaching the Fiber Optic Cable to a
Fantasea FP7000 Housing or any other
housing that features a dedicated fiber optic
cable attachment configuration (figure C),
please refer the housing instruction manual
for specific instructions regarding attaching
the fiber optic cable to the camera housing.
If attaching the Fiber Optic Cable to any other
standard camera housing, please follow the instructions below.
Figure A
Figure B
Figure C
