Fantasea FP7000 Housing Instruction Manual 20110201
13
PREPARING THE HOUSING
1.
When using the housing for the first time-
a.
Peel the screen protector off the back side of the housing.
b.
Install the hand lanyard on the housing by inserting it through the lanyard loop on the
bottom right of the housing (facing from back), then pulling it through itself and testing it
in order to make sure it is secure (image #1).
c.
Install the housing side of the diffuser quick release secure line by tying it around the
hinge found at the left side of the housing, where the Fiber Optic Cable Plate secure
string is attached to (image #2). Please note that this line may come assembled and then
there is no need for installation.
d.
If making use of a hand strap (optional), install it on the two loops found at the right side
of the housing.
e.
It is important that a first dive with the housing is always made without the camera in
order to verify that the housing watertight seal has not been affected during transport
and after long periods of storage.
OPENING THE HOUSING
1.
Lift the
small red tab located at the bottom of the latch
dial upwards, as indicated by the arrow
direction (image #3 on the following page). There is no need to apply any force.
2.
While holding the lock dial up, turn the latch dial counterclockwise until the red latch tab is
located at the top of the latch and cannot be turned any further (image #4 on the following
page). There is no need to apply any force.
3.
Carefully open the back side of the housing.
Image #1
Image #2
