© 2005-2011 Nodal Ninja
®
- 15 -
Removing and Replacing Detents
Disassemble the lower rotator assembly by
completely unscrewing the friction set knob on
top (with markings).
Using the enclosed hex key loosen the inner hex screw enough to release detent ring. Some
units may have the hex key tool located inside the tension knob as shown above left. Place
the detent ring with desired side face up. Tighten hex screw and reassemble.
At the time of this writing we have the following rings available:
−
10/12 degrees, number of stops around n = 30/36
−
15/18 degrees, number of stops around n = 24/20
−
20/24 degrees, number of stops around n = 18/15
−
30/36 degrees, number of stops around n = 12/10
−
45/60 degrees, number of stops around n = 8/6
−
90/120 degrees, number of stops around n = 4/3
−
45&60/90&120 degrees, number of stops around n = 8+6/4+3
