Model 422 & Model 422CC Instruction Manual
D01187869
Revision A, December 2015
29
This allows a very random schedule to be programmed using user selected timing
intervals.
Select Motor Speed = Bc, select the empty box under Run Time and enter the
hesitation start time in minutes using the touch pad a right. The Start Time is the
elapsed time from the beginning of the test to the first hesitation squeeze start.
Select Next Ramp to enter first stop. The screen will re-initialize - select STOP for
motor speed and enter desired amount of time for STOP segment in Run Time box.
Selecting Next Ramp again to enter run time after first STOP segment. If repeating
the schedule for the remainder of the test is desired, simply select AUTO REPEAT
after 3 segments have been entered (Bc-STOP-Bc). An infinite number of
sequences can be input. Select SAVE to save or Cancel to exit without new
schedule. A preview of the schedule will be displayed for approval.
6.4
Sample Properties
Test printouts contain information cells which can be edited by the user. Sample
properties such as well, district, cement, density, weight, water, etc. can be chosen
as suitable information. An example of these sample properties is shown below.
Properties can be added and deleted here. The value for these properties will be
selected after a test is complete. Select view test and select the test file to be
chosen. Then select the PRINTING tab on the left hand side and sample properties
can be seen and values edited accordingly.
6.5
Alarms
Consistency and time alarms can be added to and deleted from a test setup. These
alarms produce audible alerts are displayed in the test printout. An example of
programmed alarms is shown following. Factory defaults contain Bc alarms only.
