6
How to Hang
This Ceiling Fan
WARNING
The fan must be hung with at least 2.1m of
clearance from
fl
oor to blades. (Figure 8)
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or
fi
re hazard.
WARNING
To avoid possible shock, do not pinch wires between
the hanger ball assembly and the hanger bracket.
WARNING
The hanger bracket must be securely mounted and
capable of supporting at least 27 kg. If bracket and /or
timber batten are not securely attached, the fan could
wobble or fall.
WARNING
To avoid possible
fi
re or shock, be sure electricity is
turned off at the main fuse box before wiring.
(Figure 7)
Figure 8
CEILING
FLOOR
Figure 10
Figure 9
Figure 7
MAIN FUSE BOX
Screw with hex head
wood screws(2)
Not supplied
Downrod/Hanger
Ball Assembly
How to Assemble This Ceiling Fan
Figure 5
Figure 6
6.
Before installing fan, measure up approximately
15-25 cm above top of downrod/hanger ball assem-
bly. Cut off excess wire and strip back insulation 1 cm
from end of wire. (Figure 6)
NOTE: All set screws must be checked and
retightened where necessary before installation.
1.
Drill a hole in the ceiling board and batten for wiring.
Securely attach the hanger bracket to a timber batten
or other structural support using appropriate fasteners.
(Figure 9).
2.
Carefully lift the fan and seat the downrod/hanger
ball assembly on the hanger bracket that was just
attached to the timber batten. Be sure the groove
in the ball is lined up with tab on the hanger bracket
(Figure 10).
NO
LESS THAN
2.1 M
Hanger
Bracket
Hanger
Bracket
Tab
15-25 cm
Note: Ceiling board and
wiring omitted for clarity.
Note: Ceiling board and
wiring omitted for clarity.
Timber Batten
