9
How to Assemble the Blades and Light Kit
x 21
x 21
FIBER WASHER
3/16-24 x 8mm
WASHER HEAD
SCREWS
HARDWARE USED:
x 11
1/4-20 x 14mm
SCREWS
HARDWARE USED:
BLADE
3/16-24 x 7.5mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
BLADE HOLDER
Figure 2
MOTOR SUPPORT
1/4-20 x 14mm SCREWS
(2 per assembly)
BLADE HOLDER
RUBBER
MOTOR STOPS
2.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16-24 x
8 mm washer head screws and fiber washers to
secure the blade to the blade arm (Figure 2).
1.
Remove the blade bushing cover (Figure 1).
3.
Remove and discard rubber motor stops. (Figure 3)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
4.
Secure the blade holders to the motor support
using the 1/4-20 x 14mm screws through the holes
located on the top of the motor support (Figure 4).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
MOTOR
ASSEMBY
Figure 4
BLADE BUSHING COVER
Figure 1
Figure 3
