Fanimation Palmetto, Руководство пользователя, Страница: 4 / 6

1. LOCATE POWER
a. POWER IS SUPPLIED BY PURCHASER/CONTRACTOR
b. DISCONNECT POWER SUPPLY AT BREAKER BOX.
c. A SINGLE PHASE 220 TO 240VAC ELECTRICAL FEED LOCATED AT THE CENTER OF THE MOTOR ASSEMBLY
(P680M**)
d. A SINGLE PHASE 220 TO 240VAC ELECTRICAL FEED LOCATED AT THE CENTER OF THE MOTOR ASSEMBLY
(P680M**)
e. A SINGLE PHASE ELECTRICAL FEED IS REQUIRED
f. MOTOR IS SINGLE SPEED ONLY
g. DO NOT OPERATE WITH ANY SPEED CONTROL
2. INSTALLATION NOTE
a. IT IS RECOMMENDED THAT EACH CEILING MOUNT ASSEMBLY (P680M**, P600S**, AND P600D** IF REQUIRED)
HAVE ¾” PLYWOOD BACKING SECURED TO A STRUCTURAL MEMBER FOR ADEQUATE SUPPORT.
3. MOUNT MOTOR ASSEMBLY OVER POWER SUPPLY TO COVER JUNCTION BOX.
a. MARK FOUR MOUNTING HOLE POSITIONS AS REQUIRED
b. DRILL PILOT HOLES
c. START 2 SUPPLIED LAG BOLTS WITH WASHER IN THE OUTSIDE HOLES
d. DO NOT COMPLETELY TIGHTEN LAG BOLTS AT THIS TIME
e. CONNECT THE MOTOR WIRES TO THE SUPPLIED LEADS
i. BROWN TO “HOT”
ii. BLUE TO “NEUTRAL”
f. POSITION MOTOR ASSEMBLY OVER THE FINAL TWO PREDRILLED HOLES AND FASTEN WITH REMAINING LAG
BOLTS AND WASHERS
g. SECURE ALL FOUR LAG BOLTS
4. LOCATE POSITION OF EITHER END OR CENTER ASSEMBLY (P600S** OR P600D**)
a. MAXIMUM DISTANCE FROM MOTOR TO NEXT ASSEMBLY IS 9’11” CENTER OF BASE TO CENTER OF BASE OR
b. MAXIMUM DISTANCE FROM MOTOR TO NEXT ASSEMBLY IS 10’5” FROM OUTSIDE EDGE OF BASE TO OUTSIDE
EDGE OF BASE.
c. MARK FOUR MOUNTING HOLE POSITIONS AS REQUIRED
d. DRILL PILOT HOLES
e. MOUNT NEXT ASSEMBLY IN DESIRED LOCATION AND TIGHTEN ALL FOUR LAG BOLTS SECURELY
f. MEASURE DISTANCE FROM INSIDE EDGE OF COUPLER ADAPTER TO INSIDE EDGE OF COUPLER ADAPTER TO
DETERMINE LENGTH OF ROTATING SHAFT (TUBE108**)
g. CUT ROTATING SHAFT (TUBE108**) TO MEASURED LENGTH.
h. ON SECOND ASSEMBLY LOOSEN THE TWO LAG BOLTS ON THE INSIDE EDGE OF THE BASE ENOUGH TO LEAN IT
BACK.