5
Assembling Crossbar To The Extension Pole (cont’d)
¼
˝
x 2
3
⁄
16
˝
socket head bolts and locking nuts. Securely
tighten both bolt and nut sets (Figure 2).
5.
Slide Canopy over onto Extension Pole.
6.
Route wires and safety cable though the Hanger Ball
Adapter Assembly. (Figure 3)
7.
Assemble the Hanger Ball Adapter Assembly to top of
the Extension Pole with the 4 screws supplied with the
fan. (Figure 3)
8.
The fan comes with blue, black and white leads. Before
installing fan, measure up approximately 6-9 inches
above the top of the hanger adapter. Cut off excess wire
and strip back insulation ½
˝
from end of wire.
Figure 3
Setscrew
Extension
Pole
Hanger Ball
Adapter
Assembly
Pin
Screw (4)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Hanging the fan with blades connected may
result in damage to the fan blades.
▲
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
This Lag Bolt is
fastened securely
Hanger
Bracket is
loose and
free to rotate
This Lag Bolt is NOT
fully fastened
Figure 1
Fan Alignment And Hanger Bracket Installation
1.
Attaching Ceiling Support Cable (Figure 1):
Drill ¼
˝
pilot hole through one of the four corners of the junction
box, into the ceiling joist or structural member. Securely
attach the ceiling support cable with
3
⁄
8
˝
x 2
˝
lag bolt and
fl
at washer.
NOTE:
Ceiling support cable must be fastened between
fl
at washer and junction box with 2
˝
lag bolt (Figure 1).
2.
Preliminary Hanger Bracket Attachment (Figure 1):
Drill ¼
˝
pilot hole through the center of the junction
box, into the ceiling joist or structural member. Loosely
attach hanger bracket to the ceiling structure using
3
⁄
8
˝
x
5
˝
lag bolt and
fl
at washer.
DO NOT FULLY
TIGHTEN
THE LAG BOLT YET! Hanger Bracket should be free to
rotate.
▲
WARNING
Failure to follow these Hanger Bracket installation
procedures may result in damage to Hanger
Bracket.
