1.
To adjust the vertical alignment of the belt, loosen the
screw in the pulley assembly pulley with the supplied by
allen wrench to adjust the pulley so that belt is parallel
with the floor, then securely tighten the screw. (Figure 1)
2.
Remove the end cap from the pulley assembly.
Retain the end cap for later. (Figure 2)
Figure 1
Pulley
Assembly
Pulley
Assembly
Blade
ALLEN
WRENCH
6 x 90 x 32 mm
HARDWARE USED:
13
How to Mount the Fan Blades
Pulley
Motor
Assembly
Assembly
Allen Wrench
Belt
Figure 2
Figure 4
Figure 3
HARDWARE USED:
3/16
Ý
-24 Screws
(3 per assembly)
x 6
x 6
FIBER WASHER
3/16
Ŋ
-24
WASHER HEAD
SCREWS
3.
Securely fasten the two blades (not included) with
washer-head screws with fiber washers. Do not
over-tighten. (Figure 3)
4.
Assemble the end cap to the
pulley
assembly
by twisting in a clockwise direction.
(Figure 4)
CAUTION
Do not connect fan blades until the fan is completely
installed. Hanging fan with blades connected may result
in damage to the fan blades.
NOTE: Optional Wood Blade Set B7966** is available for
this assembly. Not for Damp Location usage.
