Light Kit
Assembly
Light Kit
Assembly
Light Kit
Assembly
13
How to Assemble Your Light Kit Assembly or Cap
2.
Remove the three screws in the light plate
assembly. Assemble the light kit assembly to the
light plate assembly using the previously removed
screws. (Figure 2)
4.
Assemble the LED assembly to the light kit assembly
using the screws removed in Step 3A. (Figure 4)
Light Plate
Assembly
Light Kit
Assembly
Steel Cap
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION
Figure 2
Figure 3A
Figure 4
Figure 5
Figure 3B
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
3B. (Option B--for use with steel cap)
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit assembly by
twisting in a clockwise direction. (Figure 3B)
NOTE:
If you have installed your fan with the steel cap,
skip Steps 4 and 5.
3A. (Option A--for use with light kit)
Remove the three screws in light kit assembly and
retain for Step 4. Connect the 2 pin connectors
from the LED assembly to the 2 pin connectors
from motor assembly. (Figure 3A)
Light Kit
Assembly
LED Assembly
LED Assembly
Glass
Motor
Figure 1
Light Plate
Assembly
1.
Remove one of the three screws in the adaptor
plate at the bottom of the motor assembly. Slightly
loosen the remaining two screws. Assemble the light
plate assembly to the adaptor plate of the motor
assembly using the two key slots in the light plate
assembly. Replace the third screw and secure all
three screws. (Figure 1)
5.
Secure the glass to light kit by twisting in a clockwise
direction. Twist the glass gradually
until it snaps
on to the light kit.
Do not over-tighten. (Figure 5)