Clevis Pin
Setscrew (2)
4
Electrical and Structural Requirements
Ceiling
Ceiling
Joists
2
˝
x 4
˝
Outlet
Box
Figure 1
How to Assemble Your Ceiling Fan
Pin
Setscrew
Hanger
Ball
Figure 1
1.
Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2.
Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 1) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 8.
3.
The fan comes with blue, black, and white 80
˝
wires.
Separate and untwist the three wires. Route the wires and
through the Downrod.
NOTE:
You will be using either the 6
˝
downrod supplied with
your fan or an optional downrod purchased seperately.
4.
Position Fan/Motor Assembly on round styrofoam
pedestal, for ease of assembly.
5.
Loosen the two setscrews in the Downrod Support. Align
the Clevis Pin holes in the Downrod with the holes in the
Downrod Support. Install the Clevis Pin and secure with
the Hairpin Clip. (Figure 2) Be sure to push the straight
leg of the hairpin clip through the hole near the end of the
clevis pin until the curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must be properly
installed to prevent the clevis pin from working loose. Pull
on the Downrod to make sure the clevis pin is properly
installed. (Figure 2)
Figure 2
Hairpin Clip
Downrod
Support
▲
WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
▲
WARNING
Turning off wall switch is not sufficent. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
Motor
Coupling
Cover
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit. The
outlet box must be securely anchored and capable of
withstanding a load of at least 50 lbs.
Figure 1
depicts
different structural configurations that may be used for
mounting the outlet box.
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and remove
the existing light fixture.
▲
WARNING
To reduce the risk of fire, electrical shock, or personal
injury, mount fan to outlet box marked acceptable
for fan support of 22.7 kg (50 lbs) or less. Use screws
supplied with outlet box. Most outlet boxes commonly
used for support of light fixtures are not acceptable for
fan support and may need to be replaced. Consult a
qualified electrician if in doubt.
Содержание Keoki FP4120 Series
Страница 13: ......