10983 Bennett Parkway
Zionsville, IN 46077
(888) 567-2055
FAX (866) 482-5215
Outside U.S. call (317) 733-4113
Visit Our Website www.fanimation.com
1.
Assemble two (provided) Threaded
Rods on the Crossbar. (Figure 1)
2.
Mount assembled Crossbar to
junction box with screws (provided
with your junction box) (Figure 2).
6.
Securely connect the bare copper
(Ground) wire to the (hex-head)
screw located on the Crossbar.
Securely connect the white lamp
wire to the white supply (neutral)
wire using wire nut supplied.
Securely connect the black lamp
wire wire to the black supply (hot)
wire using wire nut supplied.
(Figure 9)
3.
Carefully screw 1-foot tube
section onto the light fixture while
suspending the assembly upside
down to prevent wires from binding
and twisting within the support tube,
do not over tighten. (Figure 3)
Copyright 2004 Fanimation
Figure 2
Figure 1
Figure 7
Figure 6
7.
After connections have been
made, carefully push leads into the
outlet box. Carefully fasten the
Fixture over the Threaded Rods with
the Lockwashers and Knurled Nuts
provided. (Figure 7)
NOTE:
Be sure that the electrical
wires are completely inside the
junction box and not pinched
between the fixture and the ceiling.
9.
You have now completed the
assembly of your Hanging Pendant
lighting fixture. Restore power and
operate your light fixture with your
standard on/off light switch.
2004/12
Figure 3
Figure 4
4.
Assemble other two 1-foot support
tube sections. (Figure 4)
Figure 5
5.
Assemble the base assembly.
(Figure 5)
8.
Install 2¼
˝
glass (sold seperately)
with “glass nut”. (Figure 8a)
Install 100 watt max light bulb (not
included). (Figure 8b)
Figure 8a
Figure 8b
