Figure 1b
Figure 1a
Remote Transmitter
Unit Detail
Receiver Unit Detail
6
How to Wire Your Ceiling Fan
▲
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
If you feel that you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
NOTE: If fan or supply wires are different colors than indicated,
Figure 2
BLK-ANT
BL-AC IN L
WH-AC IN N
BLUE-FOR LIGHT DOWN
BLK-TO MOTOR L
WH-TO MOTOR N
GRN or BARE GROUND
GRN from ceiling plate
GRN from motor bracket
120 VAC SUPPLY
(User Supplied)
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Setting the Code:
The remote unit has 16 different
code combinations. To prevent possible interference from
or to other remote units such as garage door openers, car
alarm or security systems, simply change the combination
code in your transmitter and receiver. To set the code,
perform these steps.
•
Transmitter:
remove battery cover. Press firmly below
arrow and slide battery cover off. Slide code switches to
your choice of up or down position. Factory setting is all
up. Do not use this position. With a small screwdriver or
ball point pen slide firmly up or down (Figure 1a). Replace
battery cover on the transmitter.
•
Receiver:
Slide code switches to the same positions
as set on your transmitter (Figure 1b).
2. Connecting Receiver Wires:
• Connect wires as indicated: (Figure 2)
– Green
Ceiling
Plate and Motor Bracket wires to BARE
(ground) wire.
– BLACK Receiver Unit wire (AC IN L) to BLACK
supply wire.
– WHITE Receiver Unit wire (AC IN N). to WHITE
supply wire.
– WHITE Receiver Unit wire (
TO MOT
OR N) to WHITE
fan wire.
– BLACK Receiver Unit wire (
TO MOT
OR L) to BLACK
fan wire.
– BLUE Receiver Unit wire (FOR UP/DOWN LIGHT) to
BLUE light wire.
• Position all connected wires and receiver antenna to
allow installation of motor assembly.
3.
After making the wire connections, the wires should
be spread apart with the grounded conductor and the
equipment-grounding conductor on one side of the ceiling
plate and the ungrounded conductor on the other side of
the ceiling plate. The splices after being made should
be turned upward and carefully pushed up into the outlet
box.
