2
Remote Control Dip Switch Set Up
8.
To set the remote code with a small screwdriver or
ball point pen (neither included), slide dip switches
9.
Follow the app set up instructions on the following
pages.
firmly up or down to same as receiver unit. (Figure 5)
NOTE:
The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
Figure 5
Dip Switch
Remote
7.
If you have multiple fans and want to program each
fan to separate handheld controls. Slide the Dip Switch
with the same position in both receiver and handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process below for each
fans. Repeat these steps for each fan that you would
like to program to a separate handheld remote. Please
note that the wall switch that controls the power to your
fan(s) should be in the off position until you are ready to
program your handheld remote(s).
6.
If you have multiple fans and want to program all
fans to one handheld control. Slide the Dip Switch with
the same position in ALL receiver to ONE handheld to
set up the code for each fans and follow Step 1 of the
remote control speed set up process. Each fan needs
to be no more than 30 feet from the handheld control
that you would like to program. Please note the wall
switch that controls the power to your fan(s) should be
in the off position until you are ready to program your
handheld remote(s).
