Fanimation Enigma FP2120MG, Руководство пользователя, Страница: 6 / 24

Junction
Box
Ceiling
Support
Cable
Ceiling Joist
Wood Member
(2” x 4” Approx.)
Hanger Bracket
Ceiling
Downrod/Hanger
Ball Assembly
Attach
Safety Cable to
Ceiling Support
Cable
Tab
NOTE: Supply wires and
fan wires omitted for clarity
Ceiling
Floor
Ceiling
No
less than
7 ft
Blade Radius 30˝
(60˝ Blade Sweep)
6
How to Hang Your Ceiling Fan
1. Securely attach the ceiling support cable to the ceiling
joist or structural member using the
⅜
˝ x 2˝ lag bolt and
fl at washer. The lag bolt will pass through the fl at washer,
loop of the ceiling support cable, the outlet box and into
the supporting member (Figure 2). You will fi rst drill a ¼˝
pilot hole into the supporting member to prevent splitting
or cracking.
2. Securely attach the hanger bracket to ceiling junction
box acceptable for ceiling support.
NOTE: Ceiling support cable cannot be secured to
junction box only, it must be directly secured to ceiling
joist or structural member
using the
⅜
˝ x 2˝ lag bolt and
fl at washer. (Figure 2).
Figure 3
Figure 2
Figure 1
3. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger bracket
and the junction box so that electrical connections can be
made later.
4. Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached to
the ceiling joist. Be sure the groove in the ball is lined up
with tab on the hanger bracket. (Figure 3)
5. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and fi rmly tighten screw (Figure 3). Cut
off excess safety cable.
I N STALLAT I ON N OT E
If you are installing your ceiling fan on a sloped ceiling,
the hanger bracket must be mounted with the opening
parallel to the slope.
I N STALLAT I ON N OT E
Be sure that the safety cable (along with the electrical
supply wires) is pulled through the downrod when
installing the downrod.
▲
WARN I N G
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
▲
WARN I N G
To avoid possible shock, do not pinch wires between the
downrod/hanger ball assembly and the hanger bracket.
▲
WARN I N G
The fan must be hung with at least 7´ of clearance from
floor to blade (Figure 1)
▲
WARN I N G
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.