WARNING
Installed Wire Length
Wire Size A.W.G.
1 (
mm
2
)
(
mm
2
)
Up to 15.24 m (50 ft.)
15.24–30.48 m (50 –100 ft.)
Unpacking Instructions and Parts Identification
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
Wiring outlet box and box connectors must be of type re-
quired by local code. The minimum wire would be a 3-con-
ductor (2-wire with ground) of the following size:
Place the parts from the loose parts bags in a
small container to keep them from being lost. If any parts
are missing, contact your local retailer.
Materials
Check to see that you have received the following parts:
If you are uncertain of part description, refer to
exploded view illustration.
Assembly with hardware parts (Figure 1)
Assembly and hardware parts (Figure 2)
WARNING
This manual is designed to make it as easy as possible for you
n
a
f
g
n
il
i
e
c
r
u
o
y
n
i
a
t
n
i
a
m
d
n
a
,
e
t
a
r
e
p
o
,
ll
a
t
s
n
i
,
e
l
b
m
e
s
s
a
o
t
Tools Needed for Assembly
(Not Included)
• One Phillips head screwdriver
• One ¼˝ blade screwdriver
• One stepladder
• One wire stripper
Belt Clamps (2)
Rivet Tool (1)
Punch Tool (1)
Wall Control (1)
#6-32 screws (2)
“J” Lag Bolt,
1/4
”
x 2
”
(1)
Rivets, 3/32
” x 7/32” (8)
& Rivet Washers,
0.1 x 0.23 x 0.35 mm (8)
FP1280
Motor Assembly with
Switch Cap Receiver (1)
NOTE: The illustration shown is not to
scale or its actual configuration may vary.
Parts and packings subject to change
without notice.
Wire Nuts (3)
Lag Bolt,
1/4
”
x 2
”
(4)
Flat Washers,
Ø5 x Ø14 x 1mm (4)
Hardware Bags
FP1280**-220 Motor Assembly and Hardware Parts Identification
