17
How to Operate Your Ceiling Fan (Continued)
4.
If you need to replace the batteries. Remove the
battery cover from remote control by screwdriver
and retain the screw for later. (Figure 4)
3V CR2032
Battery (2 pcs)
5.
Install two 3V batteries in hand-held remote
transmitter, with fan power off. (Figure 5)
Figure 5
Figure 4
6.
Replace battery cover on the remote control and
secure with the previously removed screw. (Figure 6)
Figure 6
7.
If you have multiple fans and want to program all fans to one handheld control. Slide the Dip Switches to the
same position in ALL receivers as ONE handheld control, then follow Step 1 of the remote control speed set up
process. Each fan needs to be no more than 30 feet from the handheld control that you would like to program.
Please note the wall switch that controls the power to your fan(s) should be in the off position until you are ready
to program your handheld remote(s).
8.
If you have multiple fans and want to program each fan to separate handheld controls, slide the Dip Switches
to the same position in both receiver and handheld control, then follow Step 1 of the remote control speed set up
process below for each fan. Repeat these steps for each fan that you would like to program to a separate
handheld remote. Please note that the wall switch that controls the power to your fan(s) should be in the off
position until you are ready to program your handheld remote(s).