9
Assembling and Mounting the Fan Blades, & Adapter/Switch Hsg
NOTE:
Shipping Support Plate
MUST
be removed prior to
assembling blades!
Blade & Blade Holder Assembly:
1.
Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up. This is the side with
the threaded posts.
2.
Position the wood blade over the blade holder with the
threaded posts showing. Make sure the bottom edge of
the blade is fully seated against the blade holder.
3.
With a Philips screwdriver, tighten pan-head screws with
fiber, and flat washers to secure the blade. (Figure 1)
NOTE:
The switch cap housing
must
be removed
prior
to installing blade & blade holder assembly to the motor
hub.
4.
Attach assembled blades and blade holders to the motor
hub using the provided screws.
(Figure 2)
5.
Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.
Housing Switch Cup/Adapter Assembly:
6.
Disassemble the Housing Switch Cup/Adapter assembly
by removing three screws. (Figure 3)
7.
Assemble the Adapter assembly on the Housing Support
bracket and tighten three screws. (Figure 4)
8.
Assemble the Adapter assembly on the Housing Support
bracket and tighten three screws. (Figure 4)
9.
Securely attach the 9-pin switch cup connector to wiring
harness socket within Adapter assembly. (Figure 4)
Figure 2
Fan Blade
Screw
(2 per blade
holder)
Figure 1
Blade Holder
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲
WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
Figure 4
Figure 3
