- 4 -
③
④
Correct pairing will be confirmed by temporary switching off of the output
circuit and the LED will turn on again.
The remote control is programmed with the roller blind controller on the
basis of pairs of buttons. For FW-RC5 and FW-RC10 transmitters the sub-
sequent buttons are paired. For example, if the button "1" on the remote
control is paired with the receiver, then for the opposite direction of move-
ment the subsequent button "2" will be automatically paired.
For FW-RC4 transmitter are paired buttons that are vertically adjacent. For
example, if the button "1" on the remote control is paired with the receiver,
then for the opposite direction of movement button "3" will be automati-
cally paired.
After the device is properly connected, press and hold
the PROG button until the relay will switch on and the
communication LED will go off.
Press the selected button on a remote control or in
a flush-mounted transmitter.
②
①
The actual maximum load depends on the na-
ture and design of the receiver.
For more information visit: www.fif.com.pl.
1.5 A/250 V (AC-3)
Load capacity
Pairing
