F&F FOX HERMETIC BOX, Руководство пользователя, Страница: 14 / 16

- 14 -
No connection
to Wi-Fi network
Restoring firmware
In case of lack of access to the controller, for example due to
lost passwords, it is recommended that you reset the access
passwords and then reconnect and configure the controller
using the Fox application.
To reset passwords:
1. While the controller is operating, press and hold the RESET
button located inside the housing, on the right side of the
terminal block. When this is pressed, the green STAT light will
blink rapidly.
2. After approximately 5 seconds, the STAT light will go out and
you should then release the RESET button.
3. Press the RESET button briefly, the green STAT lamp will flash
again.
4. Press and hold the RESET button. After approx. 3 seconds, the
previously lit green STAT light will flash. After another 3 se-
conds the red ERROR lamp will light up.
5. Release the button – after a few seconds the ERROR lamp will
turn off, the STATUS lamp will turn on and the controller will
restart.
Restore factory settings