F&F DR-08, Быстрый старт

Страница: 5 / 8

- 5 -
1. Disconnect the power supply.
2. Make a mounting hole in the substrate/fit a ø60 mm flush-mo-
unted box.
3. Undermine the hooks and remove the external cover of the
sensor.
4. Connect the wires as shown in the diagram.
5. Insert the main body into the mounting hole/flush-mounted
box and screw in place.
6. Set the area of the detection field, the sensitivity of the twili-
ght automatic control unit and the switch-on time.
7. Assemble the external cover of the sensor.
8. Switch on the power supply to the sensor.
The sensor is inactive for the first 30 seconds after the
power supply is switched on. During this time, the PIR
system warms up.
Do not install the sensor in the immediate vicinity of he-
ating, air-conditioning and lighting devices.
If the motion sensor is installed too close to the switched
light source, the system may be activated, which means
that the sensor will automatically switch on and off the
light source. It is necessary to move the sensor to an ap-
propriate distance away from the light source.
Mounting