Fancom LUMINA 38, Инструкция по эксплуатации

Страница: 23 / 65

Lumina 38 Installing the Lumina 38
19
Connect the prod as follows:
1. Open the cover.
2. Connect the Lumina 38 to the manual switch.
3. Connect the manual switch to the main supply (be sure power is disconnected).
4. Connect other (signal wires) to the Lumina 38, see chapter Technical specifications.
5. Close the cover.
Always use the cable gland when connecting the Lumina 38. Use the sealing discs supplied to seal
off any unused cable glands. Use a sealant to seal all cable glands, after the computer has been
connected, to prevent the entry of moisture, dust and/or aggressive gasses.
Check that the mains voltage and frequency, for which this Fancom controller is suitable (see
chapter Technical Specifications in this manual), correspond to the mains voltage and frequency on
site.
Be sure that the Lumina 38 is properly grounded. When using metal cable trays, grounding at one
point of the tray is recommended.
The Lumina 38 should be possible to shut down with a suitable double pole switch which is easily
accessible.
Connect the Lumina 38 to a group that is fused with 16A from the main distributor and mount the
cables in separate cable trays.
Limit the length of the signal wires much as possible; avoid crossing high/low voltage wires.
To protect against lightning, place an over voltage protection device in the power supply of the
Lumina 38.
Condensation should never occur in the controller.