Fanco Infinity-ID DC, Руководство по установке

Страница: 12 / 16

11
CARE & CLEANING:
•
Periodic cleaning (approximately every 6 months) of your ceiling fan is the only maintenance
required.
•
Use a soft brush or lint free cloth to avoid scratching the finish. Please turn off electricity when you
do so.
•
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and
create the possibility of an electrical shock.
•
The motor has a permanently lubricated ball bearing and as such, is maintenance free.
NOISE :
The manufacturer warranty covers actual faults that may develop, but NOT minor complaints, e.g.
motor operation noise -
ALL ELECTRIC MOTORS ARE AUDIBLE TO SOME EXTENT ; this is more
obvious when the fan is operating at low speeds.
WOBBLE
:
•
Ceiling fans are designed to move during operation because they are not generally rigidly mounted
•
Movement of a couple of centimetres is acceptable for safe operation.
•
Balancing kits included should be used to adjust the balancing when first installed.
NORMAL WEAR AND TEAR :
Vigorous cleaning or rough handling of the fan may cause threaded components to work loose or blade
carriers to bend. This may cause the fan to wobble or may result in additional noise over time. THIS IS NOT
COVERED UNDER WARRANTY; however, proper care and maintenance of the fan can reduce or prevent
this problem.
REMOTE CONTROL SETTINGS AND OPERATION FOR DC FANS:
REVERSE FUNCTION:
The “Summer/Winter” reverse function is included in the remote control to make the fan rotate in
an anti-clockwise direction during summer.
In winter, this can be reversed, so that the blades now move in a clockwise direction. Press and hold “F/R”
button for 3 se conds to switch between “Summer” and “Winter modes.
The Hand-Held Remote-Control System is equipped with a learning frequency function which has code
combinations to prevent potential interference from other remote units. The frequency on your Receiver
and Transmitter units have been pre-set at the factory. If the remotes need programming, please following
the below instructions.
PAIRING THE REMOTE:
All Infinity-iD fans are pre-paired and there is no pairing process needed to start the fan.
If you want to reset the fan to factory setting. Please follow steps below.
1. Connect power to the fan.
2. Within 10 seconds after turning on the power, short press “ON/OFF” 3 times and hold the button
for 3 seconds. Then, the fan will beep once and it means it’s pair
ed successfully.
3. Now test the remote by pressing on speeds or light button.
4. It can take up to 10 seconds for the fan to start moving, after pressing a speed button. The fan may
move a few times slightly backwards and forwards and then will start rotating slowly whilst building
up to the correct speed. This is normal behaviour for DC fans.