Remote control
Install one 12 volt battery (type 23AE, not included) to the
remote control.
Buttons:
1- Fan speed control: controls the ceiling fan speed (I for
the lowest speed, VI for the fastest speed)
2- Fan OFF: turns the fan off
3- Reverse function: controls fan direction
4- Lighting control: adjusts the intensity of the light (if
applicable, depending on bulb).
5- CODE setting: using method as below
Step 1: Finish the installation of the ceiling fan.
Step 2: Turn the power on for the ceiling fan and within 60
seconds, press and hold SET button on back of remote
control for 5 seconds. The light of the ceiling fan flashes
twice when setup is completed.
Step 3: After setup is completed, switch to the desired
speed. The fan will run on the highest and lowest speed
first, and will then turn to the selected speed automatically.
6- Light setting: selects On/Off or Dimming function for light
<D> On/Off function without dimming (required for energy saving lamps [CFL]).
<ON> Dimming function enabled (for tungsten lamps; not compatible with energy saving lamps [CFL]).
Note: After changing the blades, the CODE setting has to be performed again.
Note: The receiver provides protection in the following two situations:
1- Lock protection: The receiver has a built-in protection against obstruction during operation. The motor will be locked
and the power will be disconnected after 30 seconds of obstruction. Please remove obstacles before restarting. To reset,
turn off the power supply to the fan motor, then restart.
2- Power surge protection: If the receiver detects a power consumption of the motor greater than 80W, the power supply
will be interrupted and operation will immediately stop. To reset, turn off the power supply to the fan motor, then restart
(after 5 seconds).
PAGE: 7 / 8
Fig.15
1
140116
F A N C O
F A N C O
2
3
4
5
6
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current limiting device to conserve
energy. The fan light will not operate if the combined wattage of the installed bulbs exceeds 190
Watts. If the fan light shuts off shortly after being switched on, it may be due to excessive current
demand. You should replace the light bulbs with lower wattage bulbs.
