![background image](http://html1.mh-extra.com/html/fanatec/csr-elite/csr-elite_manual_3349616013.webp)
5. Installation
5.1 Cockpit or simulater installation
If you prefer a permanent installation on a table or simulator you can
attach the wheel with 4 screws to any flat surface. The holes of the pre-
mounted adapter are compatible to the CSR and all Porsche wheels of
Fanatec. Alternatively you can mount the wheel straight by removing the
adapter. Please use the drilling templates in the support section of our
website to drill the holes. The length of the screws depends on the mount-
ing plate so we did not include any screws but you can use standard
metric screws with a diameter of 6 mm.
IMPORTANT!
Tighten the screws with your hands until all four are equal. Then using
your tools, slightly add a little more torque to each screw. No more than
1/2 turn on each screw. DO NOT over tighten or it may result in damage
to the wheel. Be very careful when doing this procedure! The ends of the
screws should not go more than 12 mm into the base of the wheel.
Screws that are too long could result in damage to the wheel whitch is not
covered by warranty.
Содержание CSR Elite
Страница 1: ...Manual ...
Страница 2: ......
Страница 11: ...4 Description of buttons and accessories 4 3 Shifter 6 Speed gear stick reverse 7GS Sequential gear stick 2GS ...
Страница 29: ......