Fanani myShell T.2T ZIP, Руководство по сборке

Страница: 14 / 20

13 FANANI / ASSEMBLY INSTRUCTIONS
T.2T ZIP
12 FANANI / ASSEMBLY INSTRUCTIONS
T.2T ZIP
6 Limit switches programming with remote control
3) UP LIMIT SWITCH
Press the button to reach the top limit switch until the motor stops
automatically (bottom rail stops against the box).
UP
WARNING: KEEP PRESSED THE UP BUTTON WITHOUT RELEASING IT
TILL THE BOTTOM RAIL STOPS AGAINST THE BOX AND THE MOTOR
PERCEIVES THE OBSTACLE AND MEMORIZES THE LIMIT SWITCH
i
Fabric moving
2) PREPARATION
Bring the bottom rail about cm 20 far from the box.
Fabric stopped
i
IMPORTANT:
during setting the motor enters the “DEAD MAN”
mode:
The fabric automatically moves and stops by simply pressing and releasing the UP
or DOWN buttons without need to push the Stop button, is however possible to
reach the desired position even with micro-movements.
Once the program operation is finished the motor will start againg to move
automatically.
1) ROLLER BLIND STARTING
After have powered the motor (see electrical connection) and have
choosen the channel on the remote control, keep pressed the
, the motor will confirm the operation with a PROGRAM BUTTON
DOUBLE CLICK.
In rapid sequence press the and buttons (in this order)
until the motor confirms the operation with a .
PROGRAM DOWN
CLICK
Limit switches programming with remote control 6
6)
LIMIT SWITCH CANCELLING
Erase the limit switch pushing in rapid succession the and buttons (in this order); the motor will confirm the operation
with a
Then repeat the programming operation startin from phase 3)
PROGRAM STOP
“DOUBLE CLICK”.
UP LIMIT SWITCH
i
IMPORTANT: before cancelling the limit switches make sure that the roller blind to be reset
corresponds to the selected channel (in case of multiple roller blinds)
“clic-clic”
4)
DOWNWARD LIMIT SWITCH
Press the button up to the desired limit switch position ; the
button to stop.
DOWN release DOWN
“click
5)
END OF SETTING
At the end of the procedure check the limiti switches.
20 ca.
“STOC”