FAME ML-30R Скачать руководство пользователя страница 2

2

Congratulations!

We would like to thank you for purchasing the ML-30R Electric Guitar Amplifi er. 
It has been specially designed and developed for the use with electric guitars.
Before using your new amplifi er, we advise to read the following pages carefully.

Taking care of your ML-30R

Safety Warnings

We want you to be aware of certain safety aspects, 
for reasons of product safety and liability. With all 
due respect, please read the following before 
operating your new Fame amplifi er.
•   Do not use or store your amplifi er in or near 
 

moist or wet areas.

•  Make sure that the voltage shown on the back 
 

of the amplifi er is the correct voltage for the 

 

location you are using it. The ML-30R can

 

never be used at different voltages than shown.

•  Opening the amplifi er housing must only 
 

be done by authorized personnel. No user 

 

serviceable parts inside.

•  The power amp is confi gured to deliver best 
 

tone at normal volume levels. We advise you 

 

for your own good not to expose yourself

 

to very high volume levels for long periods of

 

time. It can lead to hearing damage.

Transporting the ML-30R

•  The ML-30R is a solid state instrument 
 amplifi er. The built-in circuits are sensitive to 
 

hits, especially when hot. To avoid damaging 

 

the unit, we recommend using care during 

 

setup and tear down of the unit.

•  Allow the amplifi er to adjust to the ambient 
  temperature before operating, 10 minutes 
 

should be suffi cient in all cases. Especially the 

 

change between a cold vehicle and, in most 

 

cases, warm stages can cause condensing 

 

fl uid inside the electrical circuit. This can lead 

 

to circuit shorts.

•  For continued road use, please protect the 
 amplifi er with a professional fl ight case. Trans-
 

port only in operating position. Do not trans-

 

port upside down or on its side.

Daily use

•   Never be rough with knobs, connections or 
 

other parts of the amplifi er.

•   Be careful while pulling out cables. Pulling 
 

plugs quickly can cause damage.

•  Disconnect all cables before transporting 
 the 

unit.

•   Avoid physical shocks, such as hits or drops.
•   You should never put any heavy items on top 
 

of the ML-30R.

Cleaning the ML-30R

•   Usually it is suffi cient to wipe down the 
 

outside of the amplifi er with a slightly moist

 cleaning 

rag.

•   Do not use any abrasive cleaning chemicals.
•   Sometimes a vacuum cleaner can be used to
 

remove dust and dirt from nooks and crevices.

•   Avoid putting any vinyl on top of the unit. It
 

glues and discolours the surface.

Electric enviroment

•   This amplifi er contains electric circuits, which 
 

can cause interference when operating near 

 

Radio or TV units. If you notice any abnormal

 

noise, we recommend to put the amplifi er 

 

away from such devices.

•  Blown fuses can only be replaced with fuses 
 

of equal values. The use of incorrect fuses is 

 

prohibited and can cause severe injury or 

 

damage of the amplifi er.

•  Only use a grounded power cable in 
 good 

condition. 

Содержание ML-30R










Отзывы: