FAME CM2, Руководство пользователя

Страница: 7 / 9

ENGLISH
Specifications:
Troubleshooting:
The following overview serves as an aid for quick troubleshooting. If you should be uncertain,
contact the manufacturer, the dealer or the corresponding specialist personnel. Never open the
device yourself!
If the specified fixes have not been successful, please contact our service staff. The contact
details can be found at www.musicstore.de
Model FAME CM2
Sound conversion principle Condenser microphone
Diaphragm size 1 inch large diaphragm
Directional characteristic Cardioid characteristic
Frequency range 20 Hz – 20 kHz
Field transmission factor 7 mV / Pa (bei 1 kHz)
Output impedance 200 Ohm
Equivalent noise level, A-
weighted
24 dB-A
Sound pressure level limit for K
<0.5%
125 dB
Signal-to-noise ratio 76 dB
Connection XLR3
Power supply Phantom power +48 V
Symptom Troubleshooting
No tone
Check the cable for damage (cuts, extreme kinks,
etc.) and replace if necessary.
Check the wiring. Connectors must be fully
inserted and snap into place!
Check if the 48V phantom power is switched on at
the console/interface.
Check the setting of the preamplifier on the
console/interface/etc.
Delayed tone
Change the buffer size in the DAW settings. The
lower the number, the lower the latency. (Note:
with a low buffer size, the machine requires higher
performance. Depending on the computer, this
can lead to higher performance losses).
For more
information, please refer to the manual of each
digital audio workstation.