162236M User Manual GSM Gateway
Page 5 of 20
1. Installation
Find a suitable place where to mount the GSM gateway following these guide lines:
•
Make sure the GSM coverage is good before the GSM gateway is mounted.
Place the Gateway near a window if possible.
•
Make sure the LEDs on both sides are visible.
•
Make sure there is a power source, 230 VAC or 12-24 VDC reachable.
•
Connect the antenna. Place the antenna as far away from the Gateway as possible.
The antenna can be placed on any magnetic metal surface.
•
Connect the Fältcom ECII Flex to the Phone input.
Use the 122033 Modular cable and the terminal connector if required.
1.1 PIN code
Note: The GSM gateway must always be turned off before inserting or removing the SIM card. Please
see section “Turn off the GSM Gateway” before removing a SIM card.
Choose whether the PIN code should be activated or deactivated.
1.1.1 PIN code deactivated
Use a mobile phone or other equipment to deactivate the PIN code on the SIM card.
1.1.2 PIN code activated
The PIN code must be set to “1234”. Use a mobile phone or other equipment to set the PIN code to
“1234”.
At startup the GSM Gateway will automatically change the PIN code to a random 4-digit code to
prevent misusage of the SIM card. If the SIM card is to be used later; use the PUK code to unlock the
SIM.
1.2 Startup
Start the GSM Gateway:
•
Gently insert the SIM-card into the GSM unit as shown in the pictures above.
Make sure the cut corner of the SIM is on the left side and the connector pads facing down.
•
Connect the power cable.
The startup might take up to 30 seconds before the GSM Gateway has established a
connection with the GSM network. For information on how to understand the LED indications,
please see section 2 and section 3 below.
1.3 Turn off the GSM Gateway
1. Remove the DC power connector from the GSM Gateway.
2. Push the RESET button with a short push to turn the unit off.
1.4 Change SIM card
If the SIM-card needs to be changed; the new SIM-card must have “1234” as PIN-codes or have the
PIN-code deactivated.
1. Turn off the GSM Gateway; remove the DC power connector from the GSM Gateway.
2. Push the RESET button with a short push to turn the unit off.
3. Remove the old SIM and insert the new SIM as shown in the pictures above.
4. Connect the power cable.
